Hyundai Equus Manuals

Hyundai Azera: Rail Pressure Sensor (RPS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2025 Service ManualHyundai Azera: Rail Pressure Sensor (RPS) Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
Condition
Output Voltage (V)
Idle
 Approx. 1.2
1,500 rpm
2.0 ~ 2.2
6,300 rpm
 Approx. 2.8

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
   
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the intake manifold.
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor from the delivery pipe.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Rail Pressure Sensor Installation:
29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)
Rail Pressure Sensor (RPS) Schematic Diagrams
Circuit Diagram ...

CVVT Oil Temperature Sensor (OTS) Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

See also:

Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge con ...

AVN Head Unit Repair procedures
Removal AVN Head Unit     • Take care not to scratch the center fascia panel and related parts. • Eject all the disc before removing the AVN head unit to prevent damagin ...

Repair procedures
Inspection (With GDS) 1. Check BCM input/output specification of multifunction switch using the GDS. If the specification is abnormal, replace the lamp or wiper switch. 2. If diagnosis is ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com