Hyundai Equus Manuals

Hyundai Azera: Accelerator Position Sensor (APS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Accelerator Position Sensor (APS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification: Refer to “Specification�

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).

3.
Remove the installation bolt (B) and nuts (C), and the remove the accelerator pedal medule.

Installation
1.
Installation is reverse of removal.

Accelerator pedal module installation bolt:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Accelerator pedal module installation nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram ...

Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge con ...

See also:

Input Speed Sensor Description and Operation
Description Input speed sensor is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the Transaxle Control Module(TCM). The sen ...

Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat belts. The purpose of the pretensioner is to make sure that the seat belts fit tightly against the occupan ...

Air bag warning label
Air bag warning labels, some required by the U.S. National Highway Traffic Safety Administration (NHTSA), are attached to alert the driver and passengers of potential risks of the air bag system ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com