Hyundai Equus Manuals

Hyundai Azera: Purge Control Solenoid Valve (PCSV) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Purge Control Solenoid Valve (PCSV) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification�

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the purge control solenoid valve connector (A).
3.
Disconnect the vapor hoses (B) from the purge control solenoid valve.
4.
Remove the valve from the bracket.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Be sure not to apply oil or lubricant to the end of the hoses when connecting the PCSV hose.
   
•
Be careful of foreign material not to flow into the valve.
1.
Installation is reverse of removal.

Purge control solenoid valve bracket installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m 7.2 ~ 8.7 lb-ft)

Purge Control Solenoid Valve (PCSV) Schematic Diagrams
Circuit Diagram ...

CVVT Oil Control Valve (OCV) Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

See also:

Components and Components Location
Components Location 1. Fuel Tank2. Fuel Pump3. Fuel Filter4. Fuel Pressure Regulator5. Canister6. Fuel Tank Air Filter7. Fuel Tank Band8. Fuel Tank Pressure Sensor (FTPS)9. Canister Close V ...

Components and Components Location
Components 1. Headrest2. Headrest guide3. Front seat back cover4. Front seat back pad5. Front seat back warmer6. Front seat back board7. Front seat back frame assembly8. Front seat cushion frame ...

Injector Drive Box (IDB) Repair procedures
Removal 1. Turn the ignition switch off and disconnect the battery negative (-) cable. 2. Disconnect the injector drive box (IDB) connector (A). 3. Remove the air cleaner assembly. (Refer ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com