| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Disconnect the fuel pressure regulator valve connector. |
| 3. |
Measure resistance between the fuel pressure regulator valve terminals 1 and 2. |
| 4. |
Check that the resistance is within the specification.
Specification: Refer to “Specification”
|
|
(Refer to Fuel Delivery System - "High Pressure Fuel Pump")
(Refer to Fuel Delivery System - "High Pressure Fuel Pump")
Description
Canister Close Valve (CCV) is installed on the canister
ventilation line. It seals evaporative emission control system by
shutting the canister from the atmosphere when leakage dete ...
See also:
How does the air bag system operate
Air bags are activated (able to inflate if necessary) only when the ignition
switch is changed to the ON or START position.
Air bags inflate instantly in the event of a serious frontal or side ...
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, move the lever to the MIST position and release it
with the lever in the OFF position. The wipers will ...
Rain Sensor Schematic Diagrams
Circuit Diagram
...