Hyundai Azera: Filler-Neck Assembly Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures
| Removal |
| 1. |
Lift the vehicle. |
| 2. |
Disconnect the fuel filler hose (A). |
| 3. |
Disconnect the ventilation hose (B) from the fuel tank air filter.
|
| 4. |
Open the fuel filler door and then remove the filler-neck installation screw (A).
|
| 5. |
Remove the rear-LH wheel, tire, and the inner wheel house (A).
|
| 6. |
Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A).
|
| Installation |
| 1. |
Installation is reverse of removal.
|
Fuel Line Repair procedures
Removal
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure f ...
Accelerator Pedal Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B) and ...
See also:
Sunshade
To open the sunshade, press the sunshade control switch (1).
To close the sunshade, press the sunshade control switch (2). If you press
the switch when the sunroof glass is opened, the s ...
Seat belt restraint system
Seat belts are designed to bear upon the bony structure of the body, and should
be worn low across the front of the pelvis or the pelvis, chest and shoulders, as
applicable; wearing the lap section ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com