To stop the sliding at any point, press the sunshade control switch momentarily.
Body Control Module (BCM) Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the Reinforcing panel after loosening the ...
If engine turns over normally but does not start
1. Check fuel level.
2. With the ignition switch in the OFF position, check all connectors at the ignition
coils and spark plugs. Reconnect any that may be disconnected or loose.
3. Check the fuel ...
Specifications
Specifications
ItemsSpecificationsRated voltageDC 12VOperating temperature range-30°C ~ +80°C (-22 ~ +176°F)Rated loadLighting switch0.4A (Relay load)Wiper switch0.2A (Relay load)Washer switch0.2 ...