Hyundai Equus Manuals

Hyundai Azera: Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Removal
1.
Remove the automatic transaxle assembly.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the air breeder hose (A).
3.
Remove the valve body cover (B).
Tightening torque:
12.8 ~ 14.7 N.m (1.3 ~ 1.5 kgf.m, 9.4 ~ 10.9 lb-ft)

4.
Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

5.
Remove the solenoid valve support bracket (B) and the valve body mounting bolt (A-1ea).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.
Remove the torque converter control solenoid valve (A).

Installation
1.
Installation is the reverse of removal.
   
•
Check fluid level after fill the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
•
Replace the gasket (A) before reinstalling valve body cover.

Torque Converter Control Solenoid Valve (T/CON_VFS) Schematic Diagrams
Circuit Diagram ...

26 Brake Control Solenoid Valve(26/B_VFS) Description and Operation
Description 26 brake control solenoid valve(26/B) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26 brake. ...

See also:

Repair procedures
Starter Circuit Troubleshooting     The battery must be in good condition and fully charged. 1. Disconnect the injector connectors. 2. With the shift lever in N or P (A/T) ...

Injector Schematic Diagrams
Circuit Diagram ...

Engine Room Under Cover Repair procedures
Removal and Installation 1. Remove the engine room under cover (A) and (B). Tightening torque: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)     • When removing t ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com