Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the solenoid valve connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
Components and Components Location
Components
1. Gear knob & Gear boots2. Console upper tray complete3. Center facia side garnish [RH]4. Center facia side garnish [LH]5. Console extension cover [RH]6. Console extension cover [ ...
Components and Components Location
Components
1. Rear door trim2. Rear door inside handle cap3. Rear door module4. Rear frame inner cover5. Rear door panel6. Rear door delta lower run & channel7. Rear door frame rear garnish8 ...
Catalytic Converter Repair procedures
Removal
[Catalytic Converter (WCC)]
1.
Remove the exhaust manifold.
(Refer to Engine Mechanical System - "Exhaust Manifold")
[Catalytic Converter (UCC)]
1.
Remove the Center Muffler.
...