Replacement |
1. |
Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser.
|
2. |
Remove the desiccant (A) from condenser using a long nose plier. Check for crumbled desiccant and clogged bottom cap filter. |
3. |
Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap. |
4. |
Insert the new desiccant into the receiver drier tank. The
desiccant must be sealed in vacuum before it is exposed to air for use. |
5. |
Install the new bottom cap to the condenser.
|
Fluid Repair procedures
Service Adjustment Procedure
Oil level Check
A check of Automatic Transaxle Fluid(ATF) level is not
normally required during scheduled services. If an oil leak is found, ...
Front Oil Seal Components and Components Location
Components
1. Front oil seal
...
TPMS Receiver Schematic Diagrams
Circuit Diagram
Connector pin number
Pin NO.DiscriptionRemark1IGN2CAN_Low3-4Battery5CAN_High6Ground
...