Hyundai Azera: SS-A Solenoid Valve(ON/OFF) Schematic Diagrams

SS-A Solenoid Valve(ON/OFF) Specifications

Specifications ON/OFF Solenoid Valve(SS-A, SS-B) ? Control type : Normal low type Control pressure [kpa (kgf/cm?, psi)]490.33(5.0, 71.12) Internal resistance(?)10~11 ...

SS-A Solenoid Valve(ON/OFF) Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

See also:

Hood Latch Repair procedures
Replacement 1. Remove the front bumper cover. (Refer to Front Bumper - "Front Bumper Cover") 2. Detach the clips, then remove hood latch cover (A). 3. Remove the hood latch (A) mounting b ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and ...

SS-B Solenoid Valve(ON/OFF) Specifications
Specifications ON/OFF Solenoid Valve(SS-A, SS-B) ? Control type : Normal low type Control pressure [kpa (kgf/cm?, psi)]490.33(5.0, 71.12) Internal resistance(?)10~11 ...