Hyundai Equus Manuals

Hyundai Azera: Front Impact Sensor (FIS) Repair procedures - SRSCM - Restraint - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Front Impact Sensor (FIS) Repair procedures

Removal
   
•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the air duct (A).

3.
Remove the radiator support upper member (A).

4.
Disconnect the front impact sensor connector (A).

5.
Remove the front impact sensor mounting nut (B).
6.
Remove the front impact sensor.
Installation
   
•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting nut.

Tightening torque :
6.8 ~ 9.2 N.m (0.7 ~ 0.94 kgf.m, 5.0 ~ 6.8 lb-ft)

3.
Connect the front impact sensor connector.
4.
Install the radiator upper cover and air duct.
5.
Reconnect the battery negative cable.
6.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Front Impact Sensor (FIS) Components and Components Location
Components ...

Side Impact Sensor (SIS) Description and Operation
Description Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are ins ...

See also:

Windshield Deicer Repair procedures
Inspection 1. Remove the cowl top cover. (Refer to Windshield Wiper/Washer - "Front Wiper Motor") 2. Disconnect the windshield deicer connector from the wiper motor linkage. 3. Check for ...

Driver Airbag (DAB) Module and Clock Spring Description and Operation
Description Driver Airbag (DAB) is installed in the steering wheel and electrically connected to SRSCM via the clock spring. It protects the driver by deploying the airbag when frontal crash oc ...

Repair procedures
Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left. 2. Adjust the hood height by turning the hood overslam bumpers (C). ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com