Hyundai Equus Manuals

Hyundai Azera: Seat Belt Pretensioner (BPT) Repair procedures - Seat Belt Pretensioner - Restraint - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Seat Belt Pretensioner (BPT) Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Restraint / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Left side - Remove the seat belt lower anchor cover (A). After loosening the mounting bolt, then remove the seat belt lower anchor (B).

Right side - To remove the seat belt anchor pretensioner (C), keep on pushing the lock pin (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).

3.
Remove the door scuff trim.
4.
Remove the center pillar trim.
5.
Remove the upper anchor bolt.
6.
Disconnect the seat belt pretensioner connector (C).

7.
Loosen the seat belt pretensioner mounting bolts (A,B) and remove the seat belt pretensioner.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the seat belt pretensioner with a bolts (A,B).
Tightening torque
Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the seat belt pretensioner (BPT) connector (A).
5.
Install the upper anchor bolts.
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
6.
Install the center pillar trim.
7.
Install the door scuff trim.
8.
Left side - Install the lower anchor bolts.
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Right side - Insert the seat belt to the anchor pretensioner (A).

   
Make sure the lock pin is connected in properly.
9.
Reconnect the battery negative cable.
10.
After installing the seat belt pretensioner, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Seat Belt Pretensioner (BPT) Components and Components Location
Components ...

Anchor Pretensioner (APT) Description and Operation
Description Front seat belt anchor pretensioner operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on fr ...

See also:

Schematic Diagrams
System Block Diagram Component Parts And Function Outline Component partFunctionVehicle-speed sensorConverts vehicle speed to pulse.ECMReceives signals from sensor and control switches.Cruise cont ...

Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). Green arrow indicators on the instrument panel indicate which turn si ...

Specifications
Specifications ItemSpecificationMaster cylinder • Type • I.D. mm(in) • Piston stroke mm(in) • Fluid level switch ?Fixed type 23.81 mm (0.937 in)45 ± 1 mm (1.7 ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com