Hyundai Azera: Inhibitor Switch Specifications
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Specifications
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Specifications
| Specifications |
? Type: Combination of output signals from 4 terminals
| Power supply (V) | 12 |
| Output type | Combination of output signals |
Signal Code Table
| P | P-R | R | R-N | N | N-D | D | |
| Signal 1 | 12V | 12V | 0 | 0 | 0 | 0 | 0 |
| Signal 2 | 0 | 12V | 12V | 12V | 0 | 0 | 0 |
| Signal 3 | 0 | 0 | 0 | 12V | 12V | 12V | 0 |
| Signal 4 | 0 | 0 | 0 | 0 | 0 | 0 | 12V |
Inhibitor Switch Description and Operation
Description
Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...
Inhibitor Switch Schematic Diagrams
Circuit Diagram
...
See also:
General Information
General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before starting work.
The support rod must be inserted into the ...
Accelerator Pedal Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B) and ...
SS-A Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com