Hyundai Equus Manuals

Hyundai Azera: Oil Filter Repair procedures - Lubrication System - Engine Mechanical System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Oil Filter Repair procedures

Replacement
1.
Remove the engine cover.
2.
Wait for 5 minutes after loosening the oil filter cap to drain well the oil in the oil filter.
3.
Replace the oil filter.
(1)
Disconnect the oil filter cap from the oil filter body.

(2)
Remove the oil filter element.
(3)
Check and clean the oil filter installation surface.
(4)
Check the part number and shape of a new oil filter is same as old one.
(5)
Install a new oil filter element (A) and a new O-ring (B).
Apply clean engine oil to the new O-rings.
Lightly screw the oil filter cap into place, and tighten it until the O-ring contacts the seat.

(6)
Finally tighten it again by specified tightening torque.

Tightening torque :
35.0N.m (3.6kgf.m, 25.8lb-ft)

4.
Start the engine and check to be sure no oil is leaking from the oil filter.
5.
Recheck the engine oil level.
Oil Filter Components and Components Location
Components 1. Oil filter cap2. O-ring3. Oil filter element4. Oil filter body ...

Oil Filter Body Components and Components Location
Components 1. Oil filter body2. Gasket ...

See also:

Thermostat Components and Components Location
Components 1. Water temperature control assembly2. Thermostat3. Water inlet fitting ...

Inhibitor Switch Troubleshooting
Fault Diagnosis Fault Diagnosis for Symptom Major Symptom Expected Cause Items to Check and Measures Shift lever not operating Gear not marked on cluster Shock occurs wh ...

Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS (Refer to "Removal"). 4. After immersing the thermistor of the sensor into engine coola ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com