Hyundai Azera: Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the solenoid valve connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Schematic Diagrams
Circuit Diagram
...
SS-A Solenoid Valve(ON/OFF) Description and Operation
Description
SS-A solenoid valve is attached to the valve body and is an
on/off solenoid valve that is used to change gears. SS-A Solenoid
valve(ON/OFF) is installed at valve body. ...
See also:
Front Seat Belt Pretensioner Repair procedures
Replacement
•
When installing the belt, make sure not to damage the pretensioner.
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly") ...
Parking brake
...
Power Mosfet Repair procedures
Inspection
1.
Ignition "ON"
2.
Manually operate the control switch and measure the voltage of blower motor.
3.
Select the control switch to raise voltage until high speed.
1. Drain2. Dr ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com