Hyundai Azera: Parking Brake Cable Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the crash pad lower panel.
|
| 3. |
Remove the parking brake cable mounting nuts (A).
|
| 4. |
Remove the parking brake cable adjusting nut(A) and the fixing clip(B), and then remove the parking brake pedal.
|
| 5. |
Remove the floor console.
|
| 6. |
Remove the shift lever assembly.
|
| 7. |
Remove the parking brake cable (B) after removing the cable retainer (A).
|
| 8. |
Remove the parking brake cable fixing clip (A) and bolts. And then remove the front parking brake cable.
|
| 9. |
Raise the vehicle, and make sure it is securely supported. |
| 10. |
Remove the rear wheel & tire. |
| 11. |
Remove the parking brake cable (B) after removing the fixing clip (A).
|
| 12. |
Loosen the parking brake cable bracket bolts and remove the rear parking brake cable. |
| 13. |
Installation is reverse of removal. |
Parking Brake Pedal Assembly Repair proceduresChanging a tire with TPMS
If you have a flat tire, the low Tire Pressure and Position telltales will come
on. Have the flat tire repaired by an authorized HYUNDAI dealer as soon as possible
or replace the flat tire with the ...
Repair procedures
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner.
The procedure starts with a ...
Air bag warning label
Air bag warning labels, some required by the U.S. National Highway Traffic Safety
Administration (NHTSA), are attached to alert the driver and passengers of potential
risks of the air bag system ...