Hyundai Equus Manuals

Hyundai Azera: Rear Package Tray Trim Repair procedures - Interior Trim - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Package Tray Trim Repair procedures

Replacement
   
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Put on gloves to protect your hands.
1.
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
[LH,RH]

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

[Center]

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
Using a screwdriver or remover, remove the rear pillar trim (A).

4.
After loosening the mounting screws, then remove the luggage partition panel (A).

5.
After loosening the mounting screws, then remove the rear package tray trim (A).

6.
Installation is the reverse of removal.
   
Make sure the connector are connected in properly.
Replace any damaged clips.
Rear Package Tray Trim Components and Components Location
Component Location 1. Rear package tray trim ...

Trunk Trim
...

See also:

Rear Door Window Glass Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. After loosening the mounting screws, then remove the rear door frame rear garnish (A). 3. Loosen the r ...

Cluster ionizer Components and Components Location
Component location ...

Crankshaft Position Sensor (CKPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal 1. Turn the ignition switch OFF and disconnect the battery n ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com