Hyundai Equus Manuals

Hyundai Azera: Rear Seat Assembly Repair procedures - Rear Seat - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Seat Assembly Repair procedures

Replacement
1.
After loosening the mounting bolts, then remove the rear seat cushion assembly (A).

Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)

2.
Disconnect the rear seat cushion heater connector (A).

3.
After loosening the mounting bolts, then remove the rear seat back assembly (A).

Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)

4.
Disconnect the rear seat back heater connector (A) and airbag connector (B).
[LH]

[RH]

5.
Installation is the reverse of removal.
   
•
Make sure the connector is plugged in properly.
Rear Seat Assembly Components and Components Location
Component Location 1. Rear seat cushion assembly2. Rear seat back assembly ...

Rear Seat Back Cover Components and Components Location
Component Location 1. Rear seat back cover ...

See also:

Voice Command List
• Common Commands: These commands can be used in most operations. (However a few  commands may not be available during certain operations) FM/AM radio commands: available during FM ...

In-car sensor Description and Operation
Description 1. In-car air temperature sensor is located at the lower crash pad. 2. The sensor contains a thermistor which measures the temperature of the cabin. The signal, determined by the ...

Air Cleaner Components and Components Location
Components 1. Air duct2. Air cleaner lower cover3. Air cleaner element4. Air cleaner upper cover5. Breather hose6. Air in take hose7. Resonator8. Clamp9. Barometric pressure sensor ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com