Hyundai Azera: Rear Seat Belt Retractor Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement

•	When installing the belt, make sure not to damage the retractor.

1.	Remove the rear package tray trim. (Refer to Interior Trim - "Rear Package Tray Trim")

2.

After loosening the rear seat belt retractor (B) mounting bolt, then remove the rear seat belt (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

[Center]

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.

Installation is the reverse of removal.

•	Replace any damaged clips.

Rear Seat Belt Retractor Components and Components Location

Component Location 1. Rear seat belt retractor2. Rear center seat belt retractor ...

Rear Seat Belt Buckle Components and Components Location

Component Location 1. Rear seat belt buckle [LH]2. Rear seat belt buckle [RH] ...

See also:

Rear Bumper Cover Components and Components Location
Component Location 1. Rear Bumper Cover ...

Climate Control Air Filter Repair procedures
Replacement 1. Disconnect the damper (B) from the glove box (A) and then remove the glove box lift (C). 2. Remove the filter cover(A) with pushing the knob. 3. Replace the air filter (B), ...

SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valver connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com