Hyundai Equus Manuals

Hyundai Azera: Rear Seat Cushion Cover Repair procedures - Rear Seat - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Seat Cushion Cover Repair procedures

Replacement
   
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
•
Put on gloves to protect your hands.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the hog-ring clips (A).

3.
After removing the velcro tape (A) and hog-ring clips (B) on the rear of seat cushion and remove the rear seat cushion cover (C).

4.
Installation is the reverse of removal.
   
•
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool [C (09880-4F000)].

Rear Seat Cushion Cover Components and Components Location
Component Location 1. Rear seat cushion cover ...

Rear Back Armrest Components and Components Location
Component Location 1. Rear back armrest ...

See also:

Side Airbag (SAB) Module Components and Components Location
Components ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Heater & A/C Control Unit(Full Automatic) Components and Components Location
Components Connector pin function ConnectorPIN NoFunctionConnectorPIN NoFunctionConnector (A)1Tail (+)Connector (A)27Evaporator Sensor (+)2Sensor REF (+5V)28-3CAN HIGH29Incar Sensor (+)4CAN LOW30D ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com