Hyundai Equus Manuals

Hyundai Azera: Rear Wheel Speed Sensor Repair procedures - ESC(Electronic Stability Control) System - Brake System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Wheel Speed Sensor Repair procedures

Removal
1.
Remove the rear wheel and tire.

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.
Remove the rear wheel speed sensor mounting bolt (A).

Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 7.6 lb-ft)

3.
Remove the rear seat back.
4.
Disconnect the rear wheel speed sensor connector.
5.
Installation is the reverse of removal.
   
Install the rear sensor after lubricating the O-ring of sensor with the assembly fluid(RAREMAX AF-1).
When inserting the sensor, take care the O-ring not to be damaged.
Rear Wheel Speed Sensor Components and Components Location
Components 1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...

Yaw-rate and G Sensor Description and Operation
Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate sensor. ...

See also:

Tilting the sunroof
When the sunshade is closed If you push the sunroof control lever upward, the sunshade will slide all the way open then the sunroof glass will tilt. To stop the sunroof movement at any point, p ...

Delivery Pipe Repair procedures
Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure f ...

Components and Components Location
Component Location 1. Horn switch2. Horn relay (Engine room compartment)3. Horn - High pitch4. Horn - Low pitch5. Clock spring ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com