Inspect Glass Alignment
| 1. |
Check for abnormal noise or bending during operation. |
| 2. |
With the sunroof fully closed, check for water leakage. |
| 3. |
The roof panel (B) should be even with the movable glass (A)
weatherstrip, to within the standard value "E" all the way around. If
not, make the following adjustment.
Tightening torque :
Standard value "E" [mm(in.)]
(1) Front edge : 1.2 mm (0.0472 in.)
(2) Rear edge : 1.0 mm (0.0394 in.)
|

|
| 4. |
If the position is not as specified, lightly loosen the glass adjusting screws (A) to adjust the glass height and tighten it.
| • |
Do not damage the screws. |
|

|
Operating The Panoramaroof Emergency Handle
| 1. |
Use the panoramaroof emergency handle to close and open the panoramaroof manually for the following case only.
| A. |
To close the panoramaroof before driving a vehicle in a rainy
day or on the highway if the panoramaroof can not be closed due to
failure of the panoramaroof motor or controller. |
|
| 2. |
Operating method.
| B. |
Push the emergency handle up into the hexagonal drive of the
panoramaroof motor. You must push hard enough to disengage the motor
clutch; otherwise the emergency handle will slip due to incomplete fit
in the motor. |
| C. |
Carefully turn the emergency handle clockwise to close the panoramaroof. |
| D. |
After closing the sunroof, wiggle the handle back and forth
as you remove the tool from the motor, to ensure the motor clutch
reengages. |
| E. |
A 5mm hex socket may be used in place of the emergency handle, with a” Speeder” type handle. |
| • |
Do not use power tools to operate the panoramaroof. |
| • |
Damaged to the components may occur. |
|

|
Components (1)
1. Roof side molding [RH]2. Roof side molding [LH]3. Movable glass assembly4. Wind deflector assembly5. Panoramaroof panel assembly6. Folding cover [RH]7. Decoration cover [RH]8. D ...
Replacement
1.
Open the movable glass fully.
2.
Remove the folding cover (A).
3.
After loosening the mounting screws, then remove the movable glass (A).
•
Do no ...
See also:
Normal maintenance schedule
The following maintenance services must be performed to ensure good emission
control and performance. Keep receipts for all vehicle emission services to protect
your warranty. Where both mileage and ...
Components and Components Location
Components
1. Sub frame2. Coil spring3. Upper arm4. Assist arm5. Trailing arm6. Rear axle
...
Cluster Fascia Panel Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...