Hyundai Azera: Seat Belt Buckle Switch (BS) Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
| 2. |
Remove the front seat assembly.
|
| 3. |
Loosen the seat belt buckle mounting bolt and remove the seat belt buckle switch (A).
|
| Installation |
Be sure to install the harness wires so they will not pinch or interfere with other parts.
|
| 1. |
Remove the ignition key from the vehicle. |
| 2. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
| 3. |
Install the seat belt buckle switch.
|
| 4. |
Install the front seat assembly.
|
| 5. |
Reconnect the battery negative cable. |
| 6. |
After installing the seat belt buckle switch, confirm proper system operation:
|
Passive Occupant Detection System (PODS-F) Description and OperationCluster ionizer Repair procedures
Inspection
1.
Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch.
DisplayFail description00Normal50Cluster ionizer fault
* Diagnostic procedure refer to D ...
SS-A Solenoid Valve(ON/OFF) Description and Operation
Description
SS-A solenoid valve is attached to the valve body and is an
on/off solenoid valve that is used to change gears. SS-A Solenoid
valve(ON/OFF) is installed at valve body. ...
Rear Seat Belt Retractor Components and Components Location
Component Location
1. Rear seat belt retractor2. Rear center seat belt retractor
...