Hyundai Azera: Special Service Tools
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Automatic Transaxle System / General Information / Special Service Tools
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Automatic Transaxle System / General Information / Special Service Tools
| Special Service Tools |
| Tools (Number and name) | Illustration | Use |
| 09200-38001, 09200-3N000 Engine support fixture (Beam) |
| Removal and installation of the transaxle. Except lower supporter, use beam only with new engine support fixture supporter(SST No.:09200-2S200), engine support fixture adaptor(SST No:09200-1P000) |
| 09200-2S200 Engine support fixture (Supporter) |
| Removal and installation of the transaxle. Use this supporter with the upper beam of the engine support fixture(SST No.:09200-38001,09200-3N000) |
| 09200-1P100 Engine support fixture (Adaptor) |
| Removal and installation of the transaxle. Use this supporter with the upper beam of the engine support fixture(SST No.:09200-38001, 09200-3N000) |
| 09453-3L240 Oil seal installer |
| Installation of transaxle case oil seal. [Using with bar (SST No.:09231-H1100)] |
| 09231-H1100 Bar |
| Installation of transaxle case oil seal. [Using with oil seal installer (SST No.:09453-3L240)] |
Specifications
Specifications
ItemSpecificationsTransmission typeA6LF2Engine modelGasoline 3.3 GDITorque converter type3-element, 1-stage, 2-phase typeTorque converter sizeO260 mm (10.2362 in.)Oil pump sy ...
See also:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1.This device may not cause harmful interference, and
2.This device must accept any interference received, including interference that
may caus ...
Engine compartment
1. Engine oil dipstick
2. Engine oil filler cap
3. Engine coolant reservoir
4. Radiator cap
5. Brake fluid reservoir
6. Windshield washer fluid reservoir
7. Air cleaner
8. Positive battery te ...
Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser.
Tightening torque :
9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft)
2.
Remove ...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com