Hyundai Equus Manuals

Hyundai Azera: Rear Door Module Repair procedures - Rear Door - Body (Interior and Exterior) - Hyundai Azera 2011-2025 Service ManualHyundai Azera: Rear Door Module Repair procedures

Replacement
1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Remove the rear door outside handle.
(Refer to Rear Door - "Rear Door Outside Handle")
3.
Loosen the rear door channel mounting bolts and nut.

4.
Loosen the mounting bolt (A).

5.
After loosening the rear door module mounting bolts, then remove the rear door module (A).

Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

6.
Remove the rear door channel (A).

7.
Disconnect the connectors and rear door module wiring harness (A).

8.
Installation is the reverse of removal.
   
The area of whole parts should be applied with sufficient grease.
Make sure connectors are connected properly and each rod is connected securely.
Make sure the door locks/unlocks and opens/closes properly
Rear Door Module Components and Components Location
Component Location 1. Rear door module ...

Rear Door Outside Handle Components and Components Location
Component Location 1. Rear door outside handle ...

See also:

Tire care
For proper maintenance, safety, and maximum fuel economy, you must always maintain recommended tire inflation pressures and stay within the load limits and weight distribution recommended for your v ...

CVVT Oil Control Valve (OCV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV terminals 1 and 2. 4. Check that the resistance is within the specifi ...

Hill-start assist control (HAC)
The main intent is to prevent the vehicle from rolling backwards while driving uphill on an inclined surface. HAC holds the braking pressure built up by the driver when the vehicle is stopped for 2 ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com