Hyundai Azera: Knee Airbag (KAB) Module Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
| 2. |
Remove the crash pad lower panel.
|
| 3. |
After loosening the mounting nuts and then remove the knee airbag (A).
|
| 4. |
Disconnect the knee airbag harness connector (A).
|
| Installation |
| 1. |
Remove the ignition key from the vehicle. |
| 2. |
Disconnect the battery negative cable and wait for at least three minutes. |
| 3. |
Connect the knee airbag connector. |
| 4. |
Tighten the knee airbag mounting nuts.
|
| 5. |
Install the crash pad lower panel.
|
| 6. |
Install the crash pad side cover.
|
| 7. |
Reconnect the battery negative cable. |
| 8. |
After installing the knee airbag, confirm proper system operation:
|
Knee Airbag (KAB) Module Components and Components Location
Airbag Module Disposal Description and OperationDynamic Damper Repair procedures
Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
3.
...
If engine stalls while driving
1. Reduce your speed gradually, keeping a straight line. Move cautiously off
the road to a safe place.
2. Turn on your emergency flashers.
3. Try to start the engine again. If your vehicle will not ...
Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the ECTS connector.
3.
Remove the ECTS (Refer to "Removal").
4.
After immersing the thermistor of the sensor into engine coola ...