Hyundai Equus Manuals

Hyundai Azera: SS-B Solenoid Valve(ON/OFF) Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: SS-B Solenoid Valve(ON/OFF) Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-B Solenoid Valve(ON/OFF) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valver connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Removal
1.
Remove the battery and the battery tray.
2.
Remove the under cover (A).
Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

3.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid")
4.
Remove the valve body cover (B) and eyebolt (A).
Tightening torque:
(A) 4.9 ~ 5.9 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~ 4.3 lb-ft)
(B) 13.8 ~ 14.7 N.m (1.3 ~ 1.5 kgf.m, 9.4 ~ 10.8 lb-ft)
   
Always replace the gasket of the eyebolt use new one whenever loosening eyebolt.
   
Remove installation bolts in the engine compartment first and then remove others under the vehicle.

5.
Remove the bolt (3ea) after disconnecting the solenoid valve connector (A) and the oil temperature sensor connector (B).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.
Remove the solenoid valve (B) after removing the solenoid support (A).

Installation
1.
Installation is the reverse of removal.
   
•
When installing, apply the ATF or white vaseline to the O-ring (A) not to be damaged.

•
Check fluid level after fill the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
•
Replace the gasket (A) before reinstalling valve body cover.

SS-B Solenoid Valve(ON/OFF) Schematic Diagrams
Circuit Diagram ...

Inhibitor Switch Description and Operation
Description Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...

See also:

MEDIA MODE
Pressing the key will change the operating mode in order of CD➟USB(iPod®)➟AUX➟My Music ➟ BT Audio. If [Mode Pop up] is turned on within [Display], then pressing t ...

Camshaft Repair procedures
Removal [RH] 1. Remove the RH bank timing chain. (Refer to Timing System - "Timing Chain") 2. Remove the RH exhaust CVVT oil control valve. (Refer to Fuel System - "CVVT Oil Control Valv ...

Fuel Pressure Regulator Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the electric pump wiring connector (A) and the fuel sender connector (B). 3. Remove the c ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com