Hyundai Azera: Troubleshooting
| Troubleshooting |
| Problem Symptoms Table |
Before replacing or repairing air conditioning components,
first determine if the malfunction is due to the refrigerant charge, air
flow or compressor.
Use the table below to help you find the cause of the
problem. The numbers indicate the priority of the likely cause of the
problem. Check each part in order. If necessary, replace these parts.
After correcting the malfunction, check the complete system to ensure that performance is satisfactory.
| Standard : |
| Symptom | Suspect Area |
| No blower operation | 1. Blower fuse |
| 2. Blower relay | |
| 3. Blower motor | |
| 4. Power mosfet | |
| 5. Blower speed control switch | |
| 6. Wire harness | |
| No air temperature control | 1. Engine coolant level |
| 2. Heater control assembly | |
| 3. Air temperature control actuator | |
| No compressor operation | 1. Refrigerant capacity |
| 2. A/C Fuse | |
| 3. Compressor | |
| 4. A/C pressure transducer | |
| 5. A/C switch | |
| 6. Evaporator temperature sensor | |
| 7. Wire harness | |
| No cold air coming out | 1. Refrigerant capacity |
| 2. Refrigerant pressure | |
| 3. Drive belt | |
| 4. Compressor | |
| 5. A/C pressure transducer | |
| 6. Evaporator temperature sensor | |
| 7. A/C switch | |
| 8. Heater control assembly | |
| 9. Wire harness | |
| Insufficient cooling | 1. Refrigerant capacity |
| 2. Drive belt | |
| 3. Compressor | |
| 4. Condenser | |
| 5. Expansion valve | |
| 6. Evaporator | |
| 7. Refrigerant lines | |
| 8. A/C pressure transducer | |
| 9. Heater control assembly | |
| No engine idle-up when A/C switch ON | 1. Engine ECM |
| 2. Wire harness | |
| No air inlet control | 1. Heater control assembly |
| 2. Intake actuator | |
| No mode control | 1. Heater control assembly |
| 2. Mode actuator | |
| No cooling fan operation | 1. Cooling fan fuse |
| 2. Fan motor | |
| 3. Engine ECM | |
| 4. Wire harness |
Special Service Tools
Special Service Tools
Tool (Number and name)IllustrationUse09977-29000Disc & hub assembly bolt removerRemoval and installation of limiter assembly.
...
See also:
Wheel replacement
When replacing the metal wheels for any reason, make sure the new wheels are
equivalent to the original factory units in diameter, rim width and offset.
WARNING
A wheel that is not the correct size ...
Anti-lock brake system (ABS)
ABS (or ESC) will not prevent accidents due to improper or dangerous driving
maneuvers. Even though vehicle control is improved during emergency braking, always
maintain a safe distance between you ...
Fuel Tank Pressure Sensor (FTPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition swit ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com