Hyundai Equus Manuals

Hyundai Azera: Air Cleaner Repair procedures - Intake And Exhaust System - Engine Mechanical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Air Cleaner Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Intake And Exhaust System / Air Cleaner Repair procedures

Removal and Installation
1.
Remove the battery.
2.
Remove the engine cover.
3.
Remove the air duct (A).

4.
Remove the air cleaner assembly.
(1)
Disconnect barometric pressure sensor (BPS) connector (A)
(2)
Disconnect the breather hose (B)
(3)
Disconnect the intensifier hose (C)
(4)
Loosen the clamp (D) and then disconnect the air intake hose from the throttle body.
Tightening torque :
2.9 ~ 4.9N.m (0.3 ~ 0.5kgf.m, 2.2 ~ 3.6lb-ft)
(5)
Remove the air cleaner assembly (E).
Tightening torque :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)

5.
Install in the reverse order of removal.
Air Cleaner Components and Components Location
Components 1. Air duct2. Air cleaner lower cover3. Air cleaner element4. Air cleaner upper cover5. Breather hose6. Air in take hose7. Resonator8. Clamp9. Barometric pressure sensor ...

Surge Tank Components and Components Location
Components 1. Surge tank2. Surge tank stay ...

See also:

Removable towing hook (front, if equipped)
1. Open the trunk, and remove the towing hook from the tool case. 2. Remove the hole cover pressing the lower part of the cover on the front bumper. 3. Install the towing hook by turning it clockw ...

Cowl Side Trim Components and Components Location
Component Location 1. Cowl side trim ...

Intake Actuator Description and Operation
Description 1. The intake actuator is located at the blower unit. 2. It regulates the intake door by signal from control unit. 3. Pressing the intake selection switch will shift between re ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com