Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the heater and blower unit.
(Refer to Heater - "Heater Unit") |
3. |
Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.
|
4. |
Installation is the reverse order of removal. |
Center Pillar Trim Components and Components Location
Component Location
1. Center pillar lower trim2. Center pillar upper trim
...
Components and Components Location
Component Location
1. Driver power window switch2. Door lock switch3. IPM(Intelligent intergrated Platform Module)4. Front door lock actuator5. Rear door lock actuator6. Trunk lid open actuator7. ...
General Information
General
1.
Basically, all measurements in this manual are taken with a tracking gauge.
2.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3.
...