Hyundai Equus Manuals

Hyundai Azera: Brake Switch Repair procedures - Brake System - Brake System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Brake Switch Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the lower crash pad.
3.
Disconnect the stop lamp switch connector (A).

4.
Pull the locking plate (A) as indicated by the arrow.

5.
Turn stop lamp switch 45° counterclockwise and remove it.

Installation
1.
Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.

2.
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.

3.
Confirm the gap between stop lamp switch and bracket.

Stop lamp clearance : 1.0 ~ 2.0 mm (0.04~ 0.08 in.)

4.
Connect the stop lamp switch connector.
   
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), perform the above process again.
5.
Install the lower crash pad.
(Refer to the Body - "Crash Pad")
Rear Disc Brake Repair procedures
Removal 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Loosen the bolt & nut and then disconnect the shock absorbe ...

Parking Brake System
...

See also:

Fuel Tank Pressure Sensor (FTPS) Specifications
Specification Pressure [kPa (kgf/cm?, psi)]Output Voltage (V)-6.67 (-0.06, -0.97)0.502.5+6.67 (0.068, 0.97)4.5 ...

Repair procedures
Adjustment Inspect Glass Alignment 1. Check for abnormal noise or bending during operation. 2. With the sunroof fully closed, check for water leakage. 3. The roof panel (B) should be even ...

Repair procedures
Adjustment Transaxle Control Module(TCM) Learning When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed. In the following case, TCM ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com