Hyundai Azera: Compressor Oil Repair procedures
| Oil Specification |
| 1. |
The HFC-134a system requires synthetic (PAG) compressor oil
whereas the R-12 system requires mineral compressor oil. The two oils
must never be mixed. |
| 2. |
Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor. |
| 1. |
The oil should be free from moisture, dust, metal powder, etc. |
| 2. |
Do not mix with other oil. |
| 3. |
The water content in the oil increases when exposed to the
air. After use, seal oil from air immediately. (HFC-134a Compressor Oil
absorbs moisture very easily.) |
| 4. |
The compressor oil must be stored in steel containers, not in plastic containers. |
Oil total volume in system
PAG OIL : 100 ± 10 cc |
| 1. |
Open all the doors and the engine hood. |
| 2. |
Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position. |
| 3. |
Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system. |
| 4. |
Stop the engine. |
Components and Components Location
Refrigerant line Components and Components LocationETC (Electronic Throttle Control) System Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle ...
Seats
Driver’s seat
(1) Forward and rearward
(2) Seatback angle
(3) Seat cushion height
(4) Lumbar support
(5) Cushion extension
(6) Driver position memory system
(7) Seat warmer/ Seat warmer wit ...
Engine Coolant Temperature Sensor (ECTS) Schematic Diagrams
Circuit Diagram
...