Hyundai Azera: Engine Room Under Cover Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Room Under Cover Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Room Under Cover Repair procedures
| Removal and Installation |
| 1. |
Remove the engine room under cover (A) and (B).
|
| 2. |
Installation is reverse order of removal |
Engine Room Under Cover Components and Components Location
Components
1. Engine room front under cover2. Engine room RH Under cover3. Engine room LH Under cover
...
Engine Mounting Components and Components Location
Components
1. Transaxle mounting bracket2. Roll road bracket3. Sub frame4. Engine mounting bracket5. Engine mounting support bracket
...
See also:
Rear Door Trim Repair procedures
Replacement
•
Be careful not to scratch the door trim and other parts.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the ...
Seat belt restraint system
Seat belts are designed to bear upon the bony structure of the body, and should
be worn low across the front of the pelvis or the pelvis, chest and shoulders, as
applicable; wearing the lap section ...
Heated Oxygen Sensor (HO2S) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com