Hyundai Equus Manuals

Hyundai Azera: ESCL(Electronic Steering Column Lock) Repair procedures - Button Engine Start System - Body Electrical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: ESCL(Electronic Steering Column Lock) Repair procedures

Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash pad lower panel.
3.
Remove the steering column upper and lower shrouds.
4.
Disconnect the electronic steering column lock connector (A).

5.
Remove the electronic steering column lock after removing the shear bolts.
   
Using a suitable tool, cut slots into the heads of the shear bolts.
Wear safety glasses to protect your eyes from flying bits of metal.
Wear work gloves to protect your hands from any sharp metal edges on the shear bolt.
Installation
1.
Install the electronic steering column lock (A).
   
Do not reuse the shear bolts.
When installing the new shear bolts to the electronic steering column lock, tighten the shear bolts until its head is cut off.

Tightening torque :
7 ~ 13 N.m (0.7 ~ 1.3 kgf.m, 5 ~ 9.4 lb.ft)

2.
Install the steering column.
3.
Install the crash pad lower panel.
ESCL(Electronic Steering Column Lock) Components and Components Location
Component ...

Front / Rear Parking Assist System
...

See also:

Coolant Repair procedures
Replacement And Air Bleeding     Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure escaping from the radi ...

Reporting safety defects
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in ad ...

Keep paint and trim in good condition
Scratches or chips in the finish should be covered with "touch-up" paint as soon as possible to reduce the possibility of corrosion. If bare metal is showing through, the attention of a qu ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com