Hyundai Equus Manuals

Hyundai Azera: Front Seat Assembly Repair procedures - Front Seat - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Front Seat Assembly Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly Repair procedures

Replacement
1.
Remove the front seat track mounting cover.
2.
After loosening the seat assembly mounting bolts, remove the front seat assembly (A).
Tightening torque :
49.0 ~ 63.7N.m (5.0 ~ 6.5kgf.m, 36.2~47.0lb-ft)

3.
Disconnect the seat buckle connector (A), seat warmer connector (B), SAB connector(C), PODS connector (D).
[Driver's]

[Passenger's]

4.
Installation is the reverse of removal.
   
•
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
•
Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
•
Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
•
Set the seat into the most rearward position. Check the front mounting bolt completely.
•
Check that the seat operates to and fro smoothy and the locking portion locks properly.
Front Seat Assembly Components and Components Location
Component Location 1. Front seat assembly ...

Front Seat Shield Outer Cover Components and Components Location
Component Location 1. Front seat shield outer cover ...

See also:

Oil Level Gauge & Pipe Repair procedures
Removal and Installation 1. Remove the oil level gauge (A). Tightening torque: 18.6 ~ 22.6N.m (1.9 ~ 2.3kgf.m, 13.7 ~ 16.6lb-ft)     When installing, apply engine oil to t ...

To keep locks from freezing
To keep the locks from freezing, squirt an approved de-icer fluid or glycerine into the key opening. If a lock is covered with ice, squirt it with an approved de-icing fluid to remove the ice. If th ...

Intake Actuator Repair procedures
Inspection 1. Ignition "OFF". 2. Disconnect the intake actuator connector. 3. Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grou ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com