Overdrive clutch control solenoid valve(OD/C) is attached to
the valve body. This variable force solenoid valve directly controls the
hydraulic pressure inside the overdrive clutch.

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Specifications
Direct control VFS[OD/C]
? Control type : Normal low type
Control Pressure [kpa (kgf/cm?, psi)]500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)Current value(mA)50~850 Internal resis ...
See also:
Antenna Coil Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Disconnect the 6P connector (B) of the coil ante ...
Trunk
...
Special Service Tools
Special Tools
Tool(Number and Name)IllustrationUse09495-3K000Band installerInstallation of ear type boot band09495-33000PullerRemove the spider assembly from the driveshaft
...