Hyundai Azera: Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the solenoid valve connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
| Removal |
Replacing an on/off solenoid valve (SS-A, SS-B) does not
require additional hydraulic pressure adjustment; however, the hydraulic
pressure will need to be adjusted after replacing the VFS solenoid
valve. If replacing the VFS solenoid valve; also replace the valve body
assembly.
(Refer to Hydraulic System - "Valve Body") |
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Schematic Diagrams
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description and OperationOccupation classification system
Your vehicle is equipped with an occupant classification system in the front
passenger's seat.
The occupant classification system is designed to detect the presence of a properly-seated
front ...
Schematic Diagrams
Circuit Diagram (1)
Circuit Diagram (2)
Circuit Diagram (3)
SRSCM Connector terminal
Pin Function (Connector A)Pin Function (Connector B)1Ignition1Seat belt pretensioner [Driver] Hig ...
Engine Hanger Repair procedures
Removal and Installation
[Front engine hanger]
1.
Remove the front engine hanger (A)
Tightening torque:
44.1 ~ 53.6N.m (4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)
2.
Install in the reverse ord ...