Replacement |
1. |
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly") |
2. |
Disconnect the connector mounting clip (A). |
3. |
After loosening the mounting bolt, then remove the front seat belt buckle (A).
|
4. |
Installation is the reverse of removal. |
Inhibitor Switch Specifications
Specifications
? Type: Combination of output signals from 4 terminals
Power supply (V)12Output typeCombination of output signals
Signal Code Table
PP-RRR-NNN-DDSignal 112V12V00000Signal 20 ...
Oil Level Gauge & Pipe Repair procedures
Removal and Installation
1.
Remove the oil level gauge (A).
Tightening torque:
18.6 ~ 22.6N.m (1.9 ~ 2.3kgf.m, 13.7 ~ 16.6lb-ft)
When installing, apply engine oil to t ...
Heated Oxygen Sensor (HO2S) Specifications
Specification
[Bank 1 / sensor 2, Bank 2 / sensor 2]
A/F Ratio (?)Output Voltage(V)RICHMin. 0.8LEANMax. 0.1
ItemSpecificationHeater Resistance (?)3.3 ~ 4.1[20°C(68°F)]
[Bank 1 / sensor 1, ...