Replacement |
1. |
Remove the rear door module.
(Refer to Rear Door - "Rear Door Module") |
2. |
Disconnect the rear door latch connector (A). |
3. |
Remove the rear door latch assembly (A). |
4. |
Installation is the reverse of removal.
|
Power Out Side Mirror Switch Repair procedures
Inspection
1.
The DDM inputs can be checked using the GDS.
2.
To check the input value of door lock switch, select option "IPM".
3.
Select option "DDM (Driver Door Module)".
4.
Select ...
TJ Joint Repair procedures
Replacement
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new on ...
IMS Power Seat Control Schematic Diagrams
Circuit diagram
...