Hyundai Azera: Roof Side Molding Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures
| Replacement |
[General Type]
|
| 1. |
Using a screwdriver or remover, remove the roof side molding (A).
|
| 2. |
Installation is the reverse of removal.
|
[Panoramaroof Type]
|
| 1. |
Using a screwdriver or remover, remove the roof molding (A).
|
| 2. |
Installation is the reverse of removal.
|
Fender Garnish Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...
See also:
Front Door Latch Repair procedures
Replacement
1.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
2.
Disconnect the connector (A) and front door latch wiring harness.
3.
Remove the front door latc ...
Idler Repair procedures
Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the drive belt idler (A).
Tightening torque :
52.9 ~ 57.9N.m (5.4 ~ 5.9kgf.m, 39.1 ~ ...
Operation in foreign countries
If you are going to drive your vehicle in another country, be sure to:
Observe all regulations regarding registration and insurance.
Determine that acceptable fuel is available.
...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com