Hyundai Azera: Roll Blind Repair procedures
| Removal |
| 1. |
Remove the roof trim.
(Refer to Roof Trim - "Roof Trim Assembly") |
| 2. |
After loosening the mounting screws, then remove the roll blind lower bracket (A).
|
| 3. |
Remove the roll blind (A) by pulling it at a right angle.
|
| Installation |
| 1. |
Install is the roll blind (A).
|
| 2. |
Install the screws to the roll blind lower bracket (A).
|
| 3. |
Install the roof trim.
|
Panoramaroof Deflector Repair procedures
Panoramaroof Assembly Components and Components LocationUnderdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
SS-B Solenoid Valve(ON/OFF) Description and Operation
Description
SS-B solenoid valve is attached to the valve body and is an
on/off solenoid valve that is used to change gears. SS-B Solenoid
valve(ON/OFF) is installed at valve body. ...
Compressor Repair procedures
Removal
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negati ...