Hyundai Azera: Rear Console Cover Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Floor Console / Rear Console Cover Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

•	Put on gloves to protect your hands.

1.	Remove the console rear complete assembly. (Refer to Floor Console - " Floor Console Assembly")

2.	After loosening the mounting screws, then remove the rear console cover (A).

3.	Disconnect the connector (A).

4.

Installation is the reverse of removal.

•	Make sure the connector are connected in properly.

•	Replace any damage clips.

Rear Console Cover Components and Components Location

Component Location 1. Rear console cover ...

Console Armrest Components and Components Location

Component Location 1. Console armrest ...

See also:

GAWR (Gross axle weight rating)
This is the maximum allowable weight that can be carried by a single axle (front or rear). These numbers are shown on the certification label. The total load on each axle must never exceed its GAWR. ...

Driving off-road
Drive carefully off-road because your vehicle may be damaged by rocks or roots of trees. Become familiar with the off-road conditions where you are going to drive before you begin driving. ...

Immobilizer Control Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Disconnect the connector of the immobilizer unit ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com