Hyundai Equus Manuals

Hyundai Azera: Crash Pad Lower Panel Repair procedures - Crash Pad - Body (Interior and Exterior) - Hyundai Azera 2011-2025 Service ManualHyundai Azera: Crash Pad Lower Panel Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Lower Panel Repair procedures

Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the crash pad side cover (A).

2.
Using a screwdriver or remover, remove the fuse box cover (A).

3.
After loosening the mounting screws, then remove the crash pad lower panel (A).

4.
Disconnect the diagnosis connector (A) and connector (B).

5.
Installation is the reverse of removal.
   
•
Make sure the connector are connected in properly.
•
Replace any damaged clips.
Crash Pad Lower Panel Components and Components Location
Component Location 1. Crash pad lower panel ...

Glove Box Housing Components and Components Location
Component Location 1. Glove box housing ...

See also:

Brake fluid
Check brake fluid level in the brake fluid reservoir. The level should be between “MIN” and “MAX” marks on the side of the reservoir. Use only hydraulic brake fluid conforming to DOT 3 or DOT 4 spec ...

Engine Mounting Repair procedures
Removal and Installation [Engine mounting support bracket] 1. Install the jack to the edge of upper oil pan (A) to support the engine.     Insert the rubber block between jac ...

CVVT Oil Control Valve (OCV) Specifications
Specification ItemSpecificationCoil Resistance (?)9.4 ~ 10.4 [20°C(68°F)] ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com