Hyundai Equus Manuals

Hyundai Azera: Front Seat Assembly Repair procedures - Front Seat - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Front Seat Assembly Repair procedures

Replacement
1.
Remove the front seat track mounting cover.
2.
After loosening the seat assembly mounting bolts, remove the front seat assembly (A).

Tightening torque :
49.0 ~ 63.7N.m (5.0 ~ 6.5kgf.m, 36.2~47.0lb-ft)

3.
Disconnect the seat buckle connector (A), seat warmer connector (B), SAB connector(C), PODS connector (D).
[Driver's]

[Passenger's]

4.
Installation is the reverse of removal.
   
•
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
•
Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
•
Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
•
Set the seat into the most rearward position. Check the front mounting bolt completely.
•
Check that the seat operates to and fro smoothy and the locking portion locks properly.
Front Seat Assembly Components and Components Location
Component Location 1. Front seat assembly ...

Front Seat Shield Outer Cover Components and Components Location
Component Location 1. Front seat shield outer cover ...

See also:

A/V external amplifier Repair procedures
Removal External Amplifier 1. Remove the trunk right luggage side trim. (Refer to Body - "Trunk Trim") 2. Remove the external amplifier (A) after disconnecting the connectors and loosening t ...

Components and Components Location
Components 1. Rear door trim2. Rear door inside handle cap3. Rear door module4. Rear frame inner cover5. Rear door panel6. Rear door delta lower run & channel7. Rear door frame rear garnish8 ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Schematic Diagrams
Circuit Diagram ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com