Hyundai Azera: Seat Heater Switch Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Seat Electrical / Seat Heater Switch Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Seat Electrical / Seat Heater Switch Repair procedures
| Inspection |
Front Seat Heater Switch
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the floor console upper cover.
|
| 3. |
Remove the seat heater switch connector (A) from the floor console upper cover.
|
| 4. |
Remove the seat heater switch assembly after loosining the screws (4EA).
|
| 5. |
Operate driver seat heater switch and check that continuity exists between the terminals.
If there is no continuity, replace the seat heater switch
|
| 6. |
Operate assist seat heater switch and check that continuity exists between the terminals.
If there is no continuity, replace the seat heater switch
|
Rear Seat Heater Switch
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Open the rear seat armrest (A).
|
| 3. |
Remove the rear seat armrest upper cover (A).
|
| 4. |
Remove the seat heater switch assembly and cover (A).
|
| 5. |
Remove the seat heater switch assembly (A) after disconnecting the connector and loosening the screws.
|
| 6. |
Turn rear seat heater switch ON and check that continuity exists between the terminals.
|
| 7. |
If there is no continuity, replace the seat heater switch. |
Seat Heater Switch Schematic Diagrams
Circuit Diagram
...
Air Ventilation Seat Components and Components Location
Components (1)
1. Ventilation blower2. Ventilation ECU3. Ventilation seat switch
Components (2)
...
See also:
Emergency trunk safety release
Your vehicle is equipped with an emergency trunk release cable located inside
the trunk. If someone is inadvertently locked in the trunk, moving the handle in
the direction of the arrow will rel ...
Engine Room Under Cover Repair procedures
Removal and Installation
1.
Remove the engine room under cover (A) and (B).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
•
When removing t ...
Injector Drive Box (IDB) Repair procedures
Removal
1.
Turn the ignition switch off and disconnect the battery negative (-) cable.
2.
Disconnect the injector drive box (IDB) connector (A).
3.
Remove the air cleaner assembly.
(Refer ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com