Using the blows power of FAN on seat, remove the moisture, sweat and warmth from occupants and surface of seats.
It inhales the indoor air through the blower installed at the
seat cushion lower part, and supplies the air into the seat cushion and
the seat back through the duct.
It sends a slight air throughout the seat surface through the air channel set up at seat cushion and seat back.
| 1. |
Make sure not to spoil drink or water on the seat when equipping with ventilation system seat |
| 2. |
Because of inhaling the slight air, it is difficult to feel the air strength by the sense of touch. |
|
Removal
[Front Seat]
1.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
2.
Remove the seat back cover and cushion cover.
(Refer to Body - "Front Seat Cushion Cover") ...
See also:
Seat Belt Buckle Switch (BS) Description and Operation
Description
The SRSCM shall monitor the status of the driver and front
passenger seat belt buckle. The SRSCM provides one pin each for the
driver and front passenger seat belt buckle status inp ...
Driving off-road
Drive carefully off-road because your vehicle may be damaged by rocks or roots
of trees. Become familiar with the off-road conditions where you are going to drive
before you begin driving. ...
Rear Door Inside Handle Repair procedures
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
After loosening the mounting screws, then remove the rear door inside handle (A).
3.
Installation is t ...