Inspection |
1. |
Remove the front door trim panel.
|
2. |
Disconnect the connector from the motor. |
3. |
Connect the terminal No. 2 and No. 3 to battery voltage (12V)
and terminal No. 4 to battery (-). And then check that the motor
operates smoothly when connecting the terminals below.
If the operation is abnormal, replace the motor.
[Safety Power Window] |
1. |
Remove the rear door trim panel.
|
2. |
Disconnect the 2P connector from the motor. |
3. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor. |
CVVT Oil Temperature Sensor (OTS) Schematic Diagrams
Circuit Diagram
...
Rear Door Latch Repair procedures
Replacement
1.
Remove the rear door module.
(Refer to Rear Door - "Rear Door Module")
2.
Disconnect the rear door latch connector (A).
3.
Remove the rear door latch assembly (A).
4.
I ...
General Information
The Micro 570 Analyzer (Canada only)
The Micro 570 Analyzer provides the ability to test the
charging and starting systems, including the battery, starter and
alternator.
...