Hyundai Azera: Rear Combination Lamp Repair procedures
| Rear Combination Lamp (Outside) |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A).
|
| 3. |
Remove the nuts (4EA).
|
| 4. |
Remove the rear combination lamp (A) after disconnecting the connector.
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
If the bulbs should be only replaced without removing lamp
assembly, replace the back up lamp bulb (A) after removing the trim
cover in the trunk.
|
| 3. |
Remove the rear garnish assembly (A).
|
| Installation |
| 1. |
Install the rear combination lamp assembly after assembling the bulb. |
High Mounted stop lamp Repair procedures
Turn Signal Lamp Repair proceduresIf engine does not turn over or turns over slowly
1. If your vehicle has an automatic transaxle, be sure the shift lever is in
N (Neutral) or P (Park) and the emergency brake is set.
2. Check the battery connections to be sure they are clean and ti ...
Heater & A/C Control Unit(Full Automatic) Components and Components Location
Components
Connector pin function
ConnectorPIN NoFunctionConnectorPIN NoFunctionConnector (A)1Tail (+)Connector (A)27Evaporator Sensor (+)2Sensor REF (+5V)28-3CAN HIGH29Incar Sensor (+)4CAN LOW30D ...
Recommended cold tire inflation pressures
All tire pressures (including the spare) should be checked when the tires are
cold. “Cold Tires” means the vehicle has not been driven for at least three hours
or driven less than 1 mile (1.6 km ...