Hyundai Equus Manuals

Hyundai Azera: Turn Signal Lamp Repair procedures - Lighting System - Body Electrical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Turn Signal Lamp Repair procedures

Removal
Door mirror turn signal lamp
1.
Disconnect the negative (-) battey terminal.
2.
Remove the mirror (A).

3.
Remove the outside mirror cover (A).

4.
Remove the lower cover (A) of outside rear view mirror.

5.
Detach the lower part from the upper part after loosening screws (4EA).

6.
Remove the outside rear view mirror actuator (A) and 2 screws (B). Disconnect the connector and remove the door mirror turn signal lamp (C).

7.
The installation is the reverse of removal.
Puddle lamp
1.
Remove the puddle lamp(A) under the outside rear mirror.

Rear Combination Lamp Repair procedures
Rear Combination Lamp (Outside) 1. Disconnect the negative (-) battery terminal. 2. If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A). ...

Trunk Lamps Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp (B) when prying the clip (A) with a flat-up screwdriver. 3. Remove the luggage room lamp bulb in ca ...

See also:

Repair procedures
Inspection Check it by the procedure below to see if the function of the ECM is normal. 1. Turn the ignition key to the "ON" position. 2. Cover the front sensor to stop functioning. 3. Sh ...

Alternator Repair procedures
Removal and Installation 1. Disconnect the battery negative terminal. 2. Remove the engine cover. 3. Disconnect the alternator connector (A) and the cable (B) from the 'B' terminal. 4 ...

Front Seat Cushion Cover Repair procedures
Replacement     • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. • Take care not to bend or scratch the trim and ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com