Component Location Index |
Engine Room |
1. Receiver Drier 2. Condenser 3. Service Port (High Pressure) 4. Service Port (Low Pressure) | 5. APT 6. Compressor 7. Expansion Valve |
Interior |
Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser.
Tightening torque :
9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft)
2.
Remove ...
CVVT Oil Temperature Sensor (OTS) Description and Operation
Description
Continuous Variable Valve Timing (CVVT) system advances or
retards the valve timing of the intake and exhaust valve in accordance
with the ECM control signal which is calculated by ...
Repair procedures
Removal
Front View Camera
1.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
2.
Loosen 3 screws and disconnect the connector(6 pins). Remove the front view camera(A).
Back ...